652 571406

Seaclean 25 l

Product Group: 652 Product number: 571406

General description

Seaclean is a highly concentrated cleaner based on petroleum

solvents, emulsifying agents and surfactants. Seaclean is

formulated for cleaning double bottom, deep and wing tanks etc.,

used for fuel oils.


• The emulsifying agents in this product are biological


• Does not contain nonylphenol ethoxylates or other

estrogenic compounds

• Can be used for general removal of oil and grease from

soiled surfaces


• Highly concentrated cleaner with quick penetration and

emulsifying properties

• Economical - very low dosage rates

Ordering information

Product number Product name

571406 SEACLEAN 25 LTR

Directions for use

Cleaning of the oil side of the Lube Oil Heat Exchangers.

Cleaning is best achieved by the recirculation method using a heated 20% solution of Seaclean. The UNITOR

Chemical Cleaning Unit - Order no 613807 - is recommended to be used.

1. Disconnect the heat exchanger’s oil inlet and outlet, drain off any remaining oil.

2. Connect the discharge side of the Chemical Cleaning Unit (CCU) to the lower heat exchanger connection and

fit the return to the CCU.

3. Add the required solution to the drum and use the installed heater or live steam. Raise the temperature of the

cleaning solution between 65 to 75°C. Maintain the temperature throughout the cleaning operation. Cleaning

without heating will extend the cleaning operation.

4. Circulate the solution for 12 to 15 hours. When the cleaning is completed, drain the cleaning solution.

5. Connect a fresh water supply to the upper heat exchanger connection, and rinse until the water runs clean

from the lower connection. Flush thoroughly with fresh water.

6. When rinsing is completed, disconnect the water supply and thoroughly drain and dry the heat exchanger.

MARINE PRODUCTS MARINE CHEMICALS SAFETY MARITIME LOGISTICS SHIPS AGENCYFor heavy carbonised deposits, see Product Data Sheet for Carbon Remover.

Sampling and testing

Seaclean is formulated for cleaning double bottom, deep and wing tanks etc. used for fuel oils.




Further Technical Data

Form Liquid

Appearance Light brown

Density 0,6

Flash Point Above 61 oC

Not Compatible may swell rubber and synthetic rubber


see MSDS for more.


Chinese    Back
About Us | Contact Us | Site Map
Mob:+ 86 13512763493
Add:No 45,Jinmanyuan,No.3 Huanzhou Road, Baiyun Area,Guangzhou,China
E-mail: Service3ship@163.com
Copyright © 2007-2019 3ship.cn. All Rights Reserved