UNITOR SEACLEAN
- IMPA 652 571406
- Contact Us
SEACLEAN
货舱和双层油舱除油清洁剂
652 571406
Seaclean Product Group: 652 Product number: 571406 General description Seaclean is a highly concentrated cleaner based on petroleum solvents, emulsifying agents and surfactants. Seaclean is formulated for cleaning double bottom, deep and wing tanks etc., used for fuel oils. Features • The emulsifying agents in this product are biological degradable • Does not contain nonylphenol ethoxylates or other estrogenic compounds • Can be used for general removal of oil and grease from soiled surfaces Benefits • Highly concentrated cleaner with quick penetration and emulsifying properties • Economical - very low dosage rates Ordering information Product number Product name 571406 SEACLEAN 25 LTR Directions for use Cleaning of the oil side of the Lube Oil Heat Exchangers. Cleaning is best achieved by the recirculation method using a heated 20% solution of Seaclean. The UNITOR Chemical Cleaning Unit - Order no 613807 - is recommended to be used. 1. Disconnect the heat exchanger’s oil inlet and outlet, drain off any remaining oil. 2. Connect the discharge side of the Chemical Cleaning Unit (CCU) to the lower heat exchanger connection and fit the return to the CCU. 3. Add the required solution to the drum and use the installed heater or live steam. Raise the temperature of the cleaning solution between 65 to without heating will extend the cleaning operation. 4. Circulate the solution for 12 to 15 hours. When the cleaning is completed, drain the cleaning solution. 5. Connect a fresh water supply to the upper heat exchanger connection, and rinse until the water runs clean from the lower connection. Flush thoroughly with fresh water. 6. When rinsing is completed, disconnect the water supply and thoroughly drain and dry the heat exchanger. MARINE PRODUCTS MARINE CHEMICALS SAFETY MARITIME LOGISTICS SHIPS AGENCYFor heavy carbonised deposits, see Product Data Sheet for Carbon Remover. Sampling and testing Seaclean is formulated for cleaning double bottom, deep and wing tanks etc. used for fuel oils. Documentation SDS • SEACLEAN 25 LTR Further Technical Data Form Liquid Appearance Light brown Density 0,6 Flash Point Above 61 oC Not Compatible may swell rubber and synthetic rubber
see MSDS for more.